Kiln Components
Whether you are looking for a complete, turn-key Kiln System of for specific components, you have come to the right address.
Nyle can supply all the different components that you might need, including coils, fans, vents, doors, controls, spray systems, etc. Please see below for the most common components and call us to discuss your specific needs.
Nyle COILS come in three grades: Good, Better and Best. All three work equally well but the difference is in how the coils are made. The Good coils are copper tubes with aluminum fins in aluminum or steel casing. These are low cost and may fit those with a limited budget who will change to a better grade coil in a few years. The Better coils are also copper tubes/aluminum fins with aluminum casing but the whole coil is coated with a special corrosion resistant material, greatly extending the life cycle of the coil. The Best coils are stainless steel tubes, headers and casing with aluminum fins. These are virtually permanent coils.
Nyle FANS use our extended venturi fan housing which optimize fan performance. The motor and propellers can be reversing or non-reversing and are designed to withstand the rugged conditions in a kiln.
Nyle VENTS are aluminum and seal tight when closed with an insulated and gasketed door. The door is opened and closed by either a stainless steel pneumatic operator or a high performance electric actuator.
Nyle KILN DOORS that are rugged, reliable and well insulated. They are custom made to fit, whatever size is needed. Nyle produces double swing doors, lift and roll doors and horizontal bifold doors, dependent on your preferences and needs. All are built in our Maine plant to assure highest quality and reliable fit.
Nyle CONTROL SYSTEMS are reliable, simple to use and range from basic to state-of-the-art computer based. All are developed and supported by the Nyle Team (link to control page).
Nyle SPRAY or humidification systems are available for conditioning or stress relief. We have systems based on steam, high pressure water (700 psi) and low pressure water (60-100 psi).
Parts & Supplies
We offer all the parts and supplies that you need to run your kilns. Kiln wheels, wet bulb socks, controls, pins and more!
Please contact us to discuss your needs for parts and supplies.
Service
When you call on Nyle, you are dealing with people who know lumber and drying and have dealt with hundreds of species and systems around the world. No hustle and hassle. Just honest, straight forward information.
To answer some of your lumber drying questions, we have prepared a booklet.
Call us with your questions and let us show you why we are the world’s number one choice for lumber drying systems.
